# Generic RX888 config, adapted to the needs of both wsprdaemon to run and two websdr's (Low and High) with both 8 channels according to the doc of Clint
# 40m until 17m are overlapping, they are available in both WebSDR's
# PE0MJX 15 Feb 2024

[global]
# these next two establish defaults for all demod sections
hardware = rx888 # use built-in rx888 driver, configured in [rx888]
status = hf.local       # DNS name for receiver status and commands
samprate = 12000        # default output sample rate
mode = usb 		# default receive mode
# rest are defaults
ttl = 1
#ttl = 0                 # Too many WD sites don't have IGMP aware ethernet swtiches, so don't send radiod multicast packets out the ethernet port.
fft-threads = 4
#blocktime = 20 # allowable Opus block times: 2.5, 5, 10, 20, 40, 60, 80, 100, 120
overlap = 5 # don't change unless you know what you're doing
#iface = enp4s0

[rx888]
device = "rx888" # required so it won't be seen as a demod section
description = "rx888 wsprdaemon" # good to put callsign and antenna description in here
gain = 17 # dB
# rest are defaults
#description = "rx888"
#number = 0
#samprate = 129600000     # Hz
samprate =   64800000     # 128 Msps will eventual burn out the stock RX888 Mk II, and this 64 Msps frees much CPU on older CPUs
#calibrate = 0		  # 1e-6 is +1 ppm
#firmware = SDDC_FX3.img
#queuedepth = 16          # buffers in USB queue
#reqsize = 32             # size of each USB buffer in 16KB units
#dither = no              # built-in A/D dither
#rand = no                # Randomize A/D output bits to spread digital->analog crosstalk
#att = 0		  # PE4312 digital attenuator, 0-31.5 dB in 0.5 dB steps
#gainmode = high          # AD8370 VGA gain mode
#gain = 1.5 		  # AD8370 VGA gain, -25 to +17 dB (low gain mode) or -8 to +34 dB (high gain mode)

[WSPR]
# Bottom of 200 Hz WSPR segments on each band. Center is 1500 Hz higher
# sample rate must be 12 kHz as required by wsprd
disable = no
data = wspr-pcm.local
agc = 0
gain = 60
samprate = 12000
mode = usb
low = 1300
high = 1700
freq = "136k000 474k200 1m836600 3m568600 3m592600 5m287200 5m364700 7m038600 10m138700 13m553900 14m095600 18m104600 21m094600 24m924600 28m124600"

[WSPR-IQ]
disable = yes
data = wspr-iq.local
agc = 0
gain = 60
samprate = 16k
mode = iq
freq = "136k000 474k200 1m836600 3m568600 3m592600 5m287200 5m364700 7m038600 10m138700 13m553900 14m095600 18m104600 21m094600 24m924600 28m124600"
# If you were to want to center IQ recordings of WSPR bands on the center freqeuncy, not the Upper Sidbeand tuning frequency, then use this line:
# freq =  "137k500 475k700 1m838100 3m570100 3m594100 5m288700 5m366200 7m040100 10m140200 13m555400 14m097100 18m106100 21m096100 24m926100 28m126100"

[FT8]
disable = yes
data = ft8-pcm.local
freq = "1m840 3m573 5m357 7m074 10m136 14m074 18m100 21m074 24m915 28m074"

[60M]
disable = yes
# five fixed channels on 60 meter segment
freq = "5330k500 5346k500 5357k000 5371k500 5403k500"
mode = usb

[10m FM]
disable = yes
data = hf-pcm.local
mode = pm
freq = "29m50 29m52 29m54 29m56 29m58 29m60 29m62 29m64 29m66 29m68"

[W1AW-CW]
disable = yes
data = w1aw-pcm.local
mode = cwu
freq = "1m8025 3m5815 7m0475 14m0475 18m0975 21m0675 28m0675"

[W1AW-DIGITAL]
disable = yes
data = w1aw-pcm.local
mode = iq
freq = "3m5975 7m095 14m095 18m1025 21m095 28m095"

[W1AW-VOICE-LSB]
disable = yes
data = w1aw-pcm.local
mode = lsb
freq = "1m855 3m990 7m290"

[W1AW-VOICE-USB]
disable = yes
data = w1aw-pcm.local
mode = usb
freq = "14m290 18m160 21m390 28m590"

[WWV]
disable = yes
data = wwv-pcm.local
mode = am
freq = "2500000 5000000 10000000 15000000 20000000 25000000 3330000 7850000 14670000"       ### Added the three CHU frequencies

[WWV-IQ]
disable = yes
data = wwv-iq.local
agc = 0
gain = 60
samprate = 16k
mode = iq
freq = "2500000 5000000 10000000 15000000 20000000 25000000 3330000 7850000 14670000"       ### Added the three CHU frequencies

[HFDL]
disable = yes
data = hfdl-pcm.local
freq = "2941k 2944k 2992k 2998k 3007k 3016k 3455k 3497k 3900k 4654k 4660k 4681k 4687k 5451k 5502k 5508k 5514k 5529k 5538k 5544k 5547k \
5583k 5589k 5622k 5652k 5655k 5720k 6529k 6532k 6535k 6559k 6565k 6589k 6596k 6619k 6628k 6646k 6652k 6661k 6712k 8825k 8834k 8843k 8885k \
8886k 8894k 8912k 8921k 8927k 8936k 8939k 8942k 8948k 8957k 8977k 10027k 10060k 10063k 10066k 10075k 10081k 10084k 10087k 10093k 11184k \
11306k 11312k 11318k 11321k 11327k 11348k 11354k 11384k 11387k 13264k 13270k 13276k 13303k 13312k 13315k 13321k 13324k 13342k 13351k 13354k \
15025k 17901k 17912k 17916k 17919k 17922k 17928k 17934k 17958k 17967k 17985k 21928k 21931k 21934k 21937k 21949k 21955k 21982k 21990k 21997k"

[CB]
disable = yes
data = cb-am-pcm.local
mode = am
freq = "26m965 26m975 26m985 27m005 27m015 27m025 27m035 27m055 27m065 27m075 27m085 27m105 27m115 27m125 27m135 27m155 27m165 27m175"
freq0 = "27m185 27m205 27m215 27m225 27m255 27m235 27m245 27m265 27m275 27m285 27m295 27m305 27m315 27m325 27m335 27m345 27m355"
freq1 = "27m365 27m275 27m385 27m395 27m405"

# channels 35-40 are usually SSB (either sideband)
# 27.360 is not an official channel but is in use for LSB
[CB-LSB]
disable = yes
data = cb-lsb-pcm.local
mode = lsb
freq = "27m355 27m360 27m365 27m370 27m375 27m385 27m395 27m405 27m420 27m425 27m440 27m445 27m455"

[CB-USB]
disable = yes
data = cb-usb-pcm.local
mode = usb
freq = "27m355 27m365 27m375 27m385 27m395 27m405"

[CHP]
disable = yes
data = chp-pcm.local
mode = pm
freq = "39m140 39m220 39m240 39m340 39m360 39m400 39m440 39m600 39m720 39m800 39m920 42m340 42m920 45m420"

[HF MANUAL]
data = hf-pcm.local
freq = 0

####################################################
#######  START DEFINITIONS WEBSDR RADIO's   ########
####################################################
#####################   PE0MJX   ###################
################### Februari 2024 #################
####################################################


### For the Low WebSDR 160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m are defined
### For the High WebSDR 40m, 30m, 20m, 17m, 15m, 12m, 10mL, 10mH

[Low_1_WEBSDR_192_160m]
disable = no
demod = linear
data = 160m-websdr192-pcm.local
channels = 2
samprate = 192000
low = -95000
high = 95000
freq = "1895k"
agc = 0
gain = 25

[Low_2_WEBSDR_384_80m]
disable = no
demod = linear
data = tachtig-websdr384-pcm.local
channels = 2
samprate = 384000
low = -160000
high = 180000
freq = "3660k"
agc = 0
gain = 23

[Low_3_WEBSDR_192_60m]
disable = no
demod = linear
data = 60m-websdr192-pcm.local
channels = 2
samprate = 192000
low = -95000
high = 95000
freq = "5373k"
agc = 0
gain = 25

[Low_4_High_1_WEBSDR_384_40m]
disable = no
demod = linear
data = 40m-websdr384-pcm.local
channels = 2
samprate = 384000
low = -105000
high = 100000
freq = "7100k"
agc = 0
gain = 25

[Low_5_High_2_WEBSDR_192_30m]
disable = no
demod = linear
data = 30m-websdr192-pcm.local
channels = 2
samprate = 192000
low = -95000
high = 95000
freq = "10150k"
agc = 0
gain = 25

[Low_6_High_3_WEBSDR_384_20m]
disable = no
demod = linear
data = 20m-websdr384-pcm.local
channels = 2
samprate = 384000
low = -175000
high = 175000
freq = "14175k"
agc = 0
gain = 23

[Low_7_High_4_WEBSDR_192_17m]
disable = no
demod = linear
data = 17m-websdr192-pcm.local
channels = 2
samprate = 192000
low = -95000
high = 95000
freq = "18118k"
agc = 0
gain = 25

[Low_8_High_5_WEBSDR_768_15m]
disable = no
demod =linear
data = 15m-websdr768-pcm.local
channels = 2
samprate = 768000
low = -225000
high = 225000
freq = "21225k"
agc = 0
gain = 21

[High_6_WEBSDR_192_12m]
disable = no
demod = linear
data = 12m-websdr192-pcm.local
channels = 2
samprate = 192000
low = -95000
high = 95000
freq = "24940k"
agc = 0
gain = 25

[High_7_WEBSDR_768_10m_Low]
disable = no
demod =linear
data = 10m-Low-websdr768-pcm.local
channels = 2
samprate = 768000
low = -375000
high = 375000
freq = "28350k"
agc = 0
gain = 19

[High_8_WEBSDR_786_10m_High]
disable = no
demod =linear
data = 10m-High-websdr768-pcm.local
channels = 2
samprate = 768000
low = -375000
high = 375000
freq = "29100k"
agc = 0
gain = 19



##########################################
########## END DEFINITIONS WEBSDR ########
##########################################